Yamaha MT125 Owner's Manual page 20

INSTRUMENT AND CONTROL FUNCTIONS
ton to switch between kilometers
and miles and then press the "SE-
LECT" button for two seconds to
confirm the setting.
Tachometer
3
1
x1000r/min
km/h
ZAUM1147
1. Tachometer
2. High-rpm zone
The tachometer allows the rider to
monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the ta-
chometer will sweep across the r/min
range and then return to zero r/min in
order to test the electrical circuit.
NOTICE
Do not operate the engine in the ta-
chometer high-rpm zone.
High-rpm zone: 10000 r/min and
above
Clock
2
ODO
1
ZAUM1148
1. Clock
The clock displays when the key is
turned to "ON".
To set the clock
1. Turn the key to "ON".
2. Push the "SELECT" button for at
least two seconds.
3. When the hour digits start flash-
ing, use the "RESET" button to set
the hours.
ECAM1150
4. Push the "SELECT" button , and
the minute digits will start flashing.
5. Use the "RESET" button to set the
minutes.
6. Push the "SELECT" button and
TIP
When setting the hours and minutes,
push the "RESET" button briefly to in-
crease the increment value one by one,
or push and hold the button to increase
the increment value continuously.
1/2
Fuel meter
TRIP1
ZAUM1149
1. Fuel meter
2. Fuel level warning light "
3. Fuel reserve tripmeter
4. Information display
The fuel meter indicates the amount of
fuel in the fuel tank. The display seg-
ments of the fuel meter disappear to-
wards "E" (Empty) as the fuel level
3-5
then release it to start the clock.
Hi
Lo
x1000r/min
km/h
4
"
1 2
1/2
FTRIP
3