Yamaha MT125 Owner's Manual page 27

Right
1
2
ZAUM1163
1. Engine stop switch " / "
2. Start switch " "
3. "INFO" switch
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
INSTRUMENT AND CONTROL FUNCTIONS
ter position. To cancel the turn signal
lights, push the switch in after it has re-
3 turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12351
Start switch "
Push this switch to crank the engine
EAU12401
with the starter. See page 5-1 for start-
ing instructions prior to starting the en-
gine.
EAU12461
The engine trouble warning light and
"
ABS warning light (ABS model only)
may come on when the key is turned to
"ON" and the start switch is pushed,
". When
but this does not indicate a malfunc-
tion.
Info switch "INFO"
This switch is used to perform selec-
tions in the function display of the
multi-function meter unit and to acti-
EAU12501
" vate or deactive the high-rpm warning
light. (See page 3-4 for information on
the multi-function meter unit and page
EAU12661 3-3 for information on the tachometer
/ "
high-rpm warning light.)
" before starting
" to
EAU12713
"
EAU44712
3-12
EAUM3451
3