Removing The Front Brake Master Cylinder; Checking The Front Brake Master Cylinder; Assembling The Front Brake Master Cylinder - Yamaha YZ450F Owner's Service Manual

WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake flu-
ids may result in a harmful chemical reac-
tion, leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor
lock.
ECA13540
NOTICE
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
5. Bleed:
• Brake system
Refer to "BLEEDING THE BRAKE SYS-
TEM" on page 3-21.
6. Check:
• Brake fluid level
The minimum level mark or below  Add.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-26.
7. Check:
• Brake lever free play
Refer to "ADJUSTING THE FRONT
BRAKE" on page 3-22.
• Brake lever operation
A softy or spongy feeling  Bleed the brake
system.
Refer to "BLEEDING THE BRAKE SYS-
TEM" on page 3-21.
REMOVING THE FRONT BRAKE MASTER
EAS1SL5145
CYLINDER
TIP
Before removing the front brake master cylin-
der, drain the brake fluid from the entire brake
system.
1. Remove:
• Union bolt
• Copper washers
• Brake hoses
TIP
To drain any remaining brake fluid, place a con-
tainer under the master cylinder and the end of
the brake hose.
CHECKING THE FRONT BRAKE MASTER EAS1SL5146
CYLINDER
1. Check:
• Brake master cylinder "1"
Damage/scratches/wear  Replace.
• Brake fluid delivery passages "2"
(brake master cylinder body)
Obstruction  Blow out with compressed
air.
2. Check:
• Brake master cylinder kit
Damage/scratches/wear  Replace.
3. Check:
• Brake master cylinder reservoir cap
4. Check:
• Brake hoses
Cracks/damage/wear  Replace.
ASSEMBLING THE FRONT BRAKE MAS-
EAS1SL5147
TER CYLINDER
EWA13520
WARNING
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake com-
ponents.
Recommended brake fluid
DOT 4
1. Wash the brake master cylinder and the
brake master cylinder kit with brake fluid.
2. Install:
• Primary cylinder cup "1"
• Secondary cylinder cup "2"
Install to the brake master cylinder piston
"3".
EWA13520
4-18
FRONT BRAKE
1
2