Checking The Wheels; Checking The Wheel Bearings; Checking And Adjusting The Steering Head - Yamaha YZ450F Owner's Service Manual

2. Tighten:
• Spokes
Use a spoke nipple wrench "1" for tighten-
ing.
1
Spoke nipple wrench (6–7)
90890-01521
YM-01521
Spokes
2.5 Nm (0.25 m·kgf, 1.8 ft·lbf)
TIP
• Do not give a half turn (180 °) or more for one
tightening.
• Make sure that tightening after a break-in is
done until the initial looseness in nipples dis-
appears.
• Make sure that tightening is done in stages,
not at a time.

CHECKING THE WHEELS

EAS1SL5110
1. Check:
• Wheel (s)
Damage/out-of-round  Replace.
EWA13260
WARNING
Never attempt to make any repairs to the
wheel.
TIP
After replacing a tire or a wheel, always bal-
ance the wheel.

CHECKING THE WHEEL BEARINGS

EAS1SL5111
1. Check:
• Wheel bearings
"CHECKING THE FRONT WHEEL" on page
4-4and "CHECKING THE REAR WHEEL"
on page 4-8.
EAS1SL5112
CHECKING AND ADJUSTING THE STEER-
ING HEAD
1. Use a suitable stand to raise the front wheel
off the ground.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Check:
• Steering head
Grasp the bottom of the front fork legs and
gently rock the front fork.
Blinding/looseness  Adjust the steering
head.
3. Remove:
• Handlebar
Refer to "HANDLEBAR" on page 4-31.
• Upper bracket
Refer to "STEERING HEAD" on page 4-49.
4. Adjust:
• Steering head
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the washer "1".
b. After loosening the ring nut "2" with a steer-
ing nut wrench "3", tighten it to the specified
torque.
TIP
• Set the torque wrench at a right angle to the
steering nut wrench.
• Move the steering to the left and right a couple
of times to check that it moves smoothly.
3-33
CHASSIS
1