Yamaha YZ450F Owner's Service Manual page 161

6. Install:
• Right grip "1"
• Collar "2"
Apply adhesive to the tube guide "3".
TIP
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface "a" with a lac-
quer thinner.
• Install the grip to the tube guide so that the
grip match mark "b" and tube guide slot "c"
form the angle as shown.
b
1
7. Install:
• Collar "1"
• Rubber cover "2"
• Throttle grip "3"
TIP
Apply the lithium soap base grease on the
throttle grip sliding surface.
8. Install:
• Throttle cables "1"
TIP
Slightly coat the end of throttle cable and inside
of throttle grip with lithium-soap-based grease.
Then, mount the throttle grip onto the handle-
bar.
9. Install:
• Throttle cable housings "1"
• Screw (throttle cable housings) "2"
EWA1DX5001
After tightening the throttle cable housing
screws, check that the throttle grip "3"
moves smoothly. If it does not, retighten the
c
screws for adjustment.
3
4-35
Screw (throttle cable housings)
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
WARNING
HANDLEBAR