Yamaha TRACER MT09 TRA Owner's Manual page 76

Periodic maintenance and adjustment
1. Radiator cap
2. Radiator cap retaining bolt
3. Radiator cap retainer
6
5. Remove the coolant reservoir cov-
er and coolant reservoir by remov-
ing the bolts and collars.
3
4
1. Bolt
2. Coolant reservoir cover
3. Coolant reservoir
4. Collar
6. Remove the coolant reservoir cap.
2
1
3
1. Coolant reservoir cap
7. Drain the coolant from the coolant
reservoir by turning it upside
down.
8. Install the coolant reservoir and its
cover by placing them in the origi-
nal position, and then installing the
collars and bolts.
1
9. Remove the coolant drain bolt and
4 its gasket to drain the cooling sys-
tem.
1
2
1
1. Coolant drain bolt
2. Gasket
10. After the coolant is completely
11. Install the coolant drain bolt and
12. Pour the specified amount of the
6-14
1 2
drained, thoroughly flush the cool-
ing system with clean tap water.
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
recommended coolant into the ra-
diator and reservoir.