Yamaha TRACER MT09 TRA Owner's Manual page 26

Instrument and control functions
TIP
 –9 °C will be displayed even if the
ambient temperature falls below
–9 °C.
 The accuracy of the temperature
3
reading may be affected when rid-
ing slowly (under 20 km/h [13
mi/h]) or when stopped at traffic
signals, railroad crossings, etc.
Coolant temperature
C.TEMP
This shows the temperature of the
coolant. The coolant temperature var-
ies with changes in the weather and
engine load.
If the message "Hi" flashes, stop the
vehicle then stop the engine and let it
cool. (See page 6-38.)
TIP
The selected information display can-
not be switched while the message
˚C
Lo "Hi" is flashing.
NOTICE
Do not continue to operate the en-
gine if it is overheating.
Average fuel consumption
FUEL AVG
This function calculates the average
fuel consumption (fuel economy) of the
vehicle since it was last reset. The av-
erage fuel consumption display can be
GEAR
4
C.TEMP ˚C
Hi
ECA10022
km/L
12.3
3-11
set to "km/L" or "L/100km"; or for the
UK, when miles is selected "MPG" will
be displayed.
 The "km/L" display shows the av-
erage distance that can be trav-
eled on 1.0 L of fuel.
 The "L/100km" display shows the
average amount of fuel necessary
to travel 100 km.
 The "MPG" display shows the av-
erage distance that can be trav-
eled on 1.0 Imp.gal of fuel.
To reset the average fuel consumption
display, use the select switch to select
the information display that contains
the average fuel consumption display.
Push the "RESET" button briefly so
that the average fuel consumption dis-
play flashes, and then push the "RE-
SET" button again for 2 seconds while
the display is flashing.
TIP
After resetting the average fuel con-
sumption display, "_ _._" will be shown
until the vehicle has traveled 1 km (0.6
mi).