Yamaha TRACER MT09 TRA Owner's Manual page 35

Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Menu switch "MENU"
This switch is used to perform selec-
tions in the setting mode display of the
multi-function meter unit.
See "Multi-function meter unit" on
page 3-6 for detailed information.
EAU12735
Select switch "
" posi- This switch is used to perform selec-
tions in the information display and
setting mode display of the multi-func-
tion meter unit.
See "Multi-function meter unit" on
page 3-6 for detailed information.
Drive mode switch "MODE"
ECA10062
WARNING
Do not change the D-mode while the
vehicle is moving.
Using this switch changes the drive
mode to "STD", "A", or "B" in the fol-
lowing order:
EAU59010
STD → A → B → STD
The throttle grip must be completely
closed in order to change the drive mo-
de. (See page 3-18 for an explanation
of each drive mode.)
TIP
 The mode is set to "STD" by de-
fault. The mode resets to "STD"
when the key is turned to "OFF".
Instrument and control functions
 The selected mode is shown on
EAU59000
/ "
EAU47496
EWA15341
3-20
the drive mode display. (See page
3-9.)
3