Handlebar Switches; Pass Switch; Dimmer Switch; Turn Signal Switch - Yamaha XMAX YP250R Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Handlebar switches

Left
3
1. Pass switch "PASS"

2. Dimmer switch "

/

3. Turn signal switch "

4. Horn switch "

"
Right

1. Hazard switch "

"

2. Start switch "

"
EAU12348
Pass switch "PASS"
Press this switch to flash the head-
light.
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
"
released, the switch returns to the
/ "
center position. To cancel the turn
signal lights, push the switch in after it
has returned to the center position.
Horn switch "
Press this switch to sound the horn.
EAU12350
EAU12400
/ "
" for the high
" for the low beam.
EAU12460
/ "
". To signal a left-hand
". When
EAU12500
"
3-11
Start switch " "
With the sidestand up, push this
switch while applying the front or rear
brake to crank the engine with the
starter. See page 5-1 for starting ins-
tructions prior to starting the engine.
The engine trouble warning light will
come on when the key is turned to
"ON" and the start switch is pushed,
but this does not indicate a malfunc-
tion.
Hazard switch " "
With the key in the "ON" or "
position, use this switch to turn on the
hazard lights (simultaneous flashing
of all turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the
engine not running, otherwise the
battery may discharge.
EAU12721
EAU41700
EAU12733
"
ECA10061