Yamaha XMAX YP250R Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
The self-diagnosis
detects problems in the immobilizer
system circuits.
If a problem is detected in the immo-
bilizer system circuits, the immobilizer
system indicator light will flash and
the multi-function display will indicate
an error code when the key is turned
3
to "ON".
TIP
If the multi-function display indicates
error code 52, this could be caused
by transponder interference. If this
error appears, try the following.
1
1. Error code display
device also 1. Use the code re-registering key
to start the engine.
TIP
Make sure there are no other immobi-
lizer keys close to the main switch,
and do not keep more than one
immobilizer key on the same key ring!
Immobilizer system keys may cause
signal interference, which may pre-
vent the engine from starting.
2. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
3. If one or both of the standard
keys do not start the engine, take
the vehicle, the code re-registe-
ring key and both standard keys
to a Yamaha dealer and have the
standard keys re-registered.
If the multi-function display indicates
any error codes, note the code num-
ber, and then have a Yamaha dealer
check the vehicle.
Clock mode
To set the clock:
1. Push the "SELECT" button and
2. When the hour digits start flas-
3. Push the "SELECT" button, and
3-9
"RESET" button together for at
least two seconds.
hing, push the "RESET" button to
set the hours.
the minute digits will start flas-
hing.