Toshiba 2000 User Manual page 37

Chapter 5 Transmission
When using this module, you must set the transmission parameters using the PROFIBUS
configurator, in addition to the controller setup and registration.
Use the following PROFIBUS configurator:
Name:
PROFIBUS SYSTEM CONFIGURATOR
HMS SYCON
Manufacturer:
HMS INDUSTRIAL NETWORKS AB
Supported OS:
Windows95, Windows98, WindowsNT4.0 with Service Pack3 or higher, Windows2000
The basic setup procedure is described below.
configurator for more information.
• Start HMS SyCon.
• Select [File]-[New] to create a new file, open the busline window and enter the
configuration mode.
• Add masters on the bus. (Select Profibus-DP Master provided by HMS for PF611.)
• Add a slave and assign it to a master. (Select AnyBus-S provided by HMS for PF612.)
• Set the I/O modules and parameters for the added slave.
• Select a master to check the attributes and connection between devices and then check
other masters to verify the setting.
• Select the baud rate and bus parameters.
• Set how HMS SyCon and master should communicate.
• Save the settings.
• Select the port to download to the master and download.
• Connect the PROFIBUS cable between devices. Enter debug mode to check the
communication status and perform I/O monitor test.
• Print out the documents of the set PROFIBUS system.
• When PROFIBUS runs normally, install the applications.
6F8C1147
Parameter Setup
Refer to the manuals for the above
21