Starting A Warm Engine; Break-In Procedures - Yamaha YZ250F Owner's Service Manual

7. To stop the engine, push the engine stop
switch "1".
TIP
Continue pushing the engine stop switch till the
engine comes to a full stop.

STARTING A WARM ENGINE

EAS1SM5045
When the engine is warm, give a kick with the
throttle closed without using the starter knob/
idle screw.
TIP
If it fails to start, fully open the throttle grip and
give 10 to 20 slow kicks to clear the engine of
the rich air-fuel mixture retained in it.

BREAK-IN PROCEDURES

EAS1SM5046
A break-in is important so that rotating portion,
sliding surfaces, and mounted areas may fit
one another, and that the rider may become ac-
customed to the machine.
ECA
NOTICE
Before running, do maintenance on the air
filter element.
Refer to "CLEANING THE AIR FILTER ELE-
MENT" on page 3-12.
1. After warming up the engine, drive it for
about 20 minutes at a throttle opening of 1/2
or less.
2. Make a pit stop, and check mounted areas
for looseness, oil leaks, or other problems.
3. Then, drive it for about 40 minutes at a throt-
tle opening of 3/4 or less.
4. Make a pit stop again, and thoroughly check
mounted areas for looseness, oil leaks, or
other problems. Thorough checks and ad-
justments are required in particular for
stretch of cables, free play of the brake,
stretch of the drive chain, looseness of the
spoke, and so on.
ECA
STARTING AND BREAK-IN
NOTICE
After a break-in or after each race, always
check the points shown in "TORQUE-
CHECK POINTS" for tightening torques and
retighten them. (Refer to "TORQUE-CHECK
POINTS" on page 1-25.)
Also when the following parts are replaced,
a break-in is required.
• Cylinder and Crankshaft: A break-in is re-
quired for about an hour.
• Piston, Piston ring, Valve, Camshaft, and
Gear: A break-in is required for about 30
minutes at a throttle opening of 1/2 or less.
Observe the condition of the engine careful-
ly during a break-in.
For checkpoints for a break-in, see "MAIN-
TENANCE AFTER BREAK-IN". If any prob-
lem is found, immediately stop the engine
and make a checkup.
1-23