Storage - Toro 30845 Operator's Manual

3
5
4
1
Figure 17
1. Front roller
2. Mounting bolt
3. Bearing
4. Push the second bearing out in press.
5. Inspect the roller housing, bearings, and bearing
spacer for damage (Figure 17). Replace damaged
components and assemble.
Assembling the Front Roller
1. Press the first bearing into the roller housing
(Figure 17). Press on the outer race only or equally
on the inner and outer race.
2. Insert the spacer (Figure 17).
3. Press the second bearing into the roller housing
(Figure 17) pressing equally on the inner and outer
race until the inner race comes in contact with the
spacer.
4. Loosely install the roller assembly and roller position
spacer into the deck frame with the mounting bolt.
Note: In some grass conditions, the quality of cut
may be improved by moving the roller position
spacer to the inside of the roller (Figure 17).
Important: Securing the roller assembly with
a gap larger than 0.060 inch (1.5 mm) creates
a side load on the bearing and can lead to
premature bearing failure.
5. Verify that there is no more than a 0.060 inch
gap between roller assembly and the roller mount
brackets of the deck frame. If there is a gap over
0.060 inch, install enough 5/8 inch diameter washers
to take up the slop.
6. Secure the mounting bolt to 80 ft-lb (108 N-m).
2
G011610
4. Bearing spacer
5. Roller position spacer

Storage

If the cutting deck is separated from the traction unit for
any length of time, install a spindle plug in the top of the
spindle to protect the spindle from dust and water.
14