Toro 03180 Operator's Manual page 7

6
Installing the Fixed Plate Kit
(Optional)
Parts needed for this procedure:
1 Fixed plate kit (not included)
Procedure
1. Remove the nuts and washers securing the lift links
to the cutting unit side plate and carrier frame
(Figure 10).
1. Nuts
2. Using the number 2 holes, insert a fixed plate onto
the bolts and secure with the nuts removed. The
number 1 holes are to be positioned toward the
front. Do not reuse the washers.
Note: Number 1 is a less aggressive setting and
number 3 is a more aggressive setting.
Figure 9
2. Washers
1. Nuts
3. Loosen the locknuts securing the height-of-cut
brackets to the cutting unit side plates (Figure 11).
1. Height-of-cut bracket
2. Locknut
4. Remove the height-of-cut brackets and the roller
from the cutting unit.
5. Repeat the procedure on the remaining cutting units.
7
Figure 10
2. Fixed plate
Figure 11
3. Adjusting screw