Maintenance; Recommended Maintenance; Schedule(S); Lubrication - Toro 30433 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the rst 8 operating
hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Before storage
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the spark plug wire from the spark plug(s)
before you do any maintenance. Set the wire aside so that it does not accidentally contact
the spark plug.

Lubrication

Grease with No. 2 general purpose lithium base or
molybdenum base grease.
Maintenance Procedure
• Check the hydraulic uid level.
• Check the safety system.
• Grease the front caster pivot bearing.
• Check the engine oil level.
• Clean the air intake screen.
• Check the brakes.
• Inspect the blades.
• Clean and re-oil the foam element (more often in dusty dirty conditions).
• Check the hydraulic uid level.
• Grease the side bearings.
• Grease the PTO belt idler.
• Check the tire pressure.
• Check the mower belt.
• Replace the paper element (more often in dusty dirty conditions).
• Change the engine oil.
• Adjust the electric clutch.
• Check the hydraulic lines.
• Replace the oil lter.
• Check the spark plug.
• Replace the fuel lter.
• Grease the front wheel bearings (more often in dirty or dusty conditions).
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
30

How to Grease

1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.