Table of Contents
Advertisement
3. Clean the grease fittings with a rag. Make
sure to scrape any paint off the front of the
fitting(s).
4. Connect a grease gun to the fitting. Pump
grease into the fittings until grease begins to
ooze out of the bearings.
5. Wipe up any excess grease.
Where to Add Grease
Lubricate the grease fittings as shown on the
Check Service Reference Aid decal (Figure 29).
Figure 29
Lubricating the Bearings
1. Lubricate the front wheel bearings and front
spindles (Figure 30).
Note: Make sure the rear wheel grease caps
are removed before lubricating rear wheels.
Figure 30
2. Grease the bearings on both sides of the
machine (Figure 31).
Figure 31
Greasing the PTO Drive Belt
Idler
Grease the fitting on the PTO belt idler arm pivot
(Figure 32).
Note: You will have to remove the carrier covers
to access the grease fitting for the deck.
31
Advertisement
Table of Contents
