Installing The Control Rods - Toro 30433 Operator's Manual

Figure 6
1. Fuel line
2. Grommet and hole
Note: Remove the plastic cap from the fuel
fitting before installing the fuel line.
3. Push the fuel line onto the fuel tank connection
and secure it with the hose clamp that is on
the fuel line (Figure 7).
Note: To ease assembly of the fuel line to the
fuel tank connection, apply a light lubricant,
®
such as WD-40 to the end of the fuel line.
Figure 7
1. Fuel line
2. Clamp
4. Secure the right side of the fuel tank to the
rear frame with 2 bolts (5/16 x 7/8 inch), lock
washers (5/16 inch) and washers (5/16 inch)
(Figure 8).
5. Secure the left side of the fuel tank to the rear
frame with washers (5/16 inch), springs and
locknuts (5/16 inch) (Figure 8).
Note: Tighten left side of the fuel tank until
it is completely tight and then unscrew the
locknut one full turn. This will allow the spring
to work.
3. Hydraulic oil lter bracket
4. Brake handle
3. Fuel tank connectin
Figure 8
1. Bolt, (5/16 x 7/8 inch)
2. Lock washer, (5/16 inch)
3. Washer, (5/16 inch)
4. Grommet and hole
Step
4

Installing the Control Rods

Parts needed for this step:
2 Control rods
2
E-ring
Procedure
1. For a starting point, make sure the rod fittings
are threaded approximately 2-1/2 inches (63
mm) onto the control rods (Figure 9)..
2. Install the control rod fittings into the control
arm and secure them with E-rings (Figure 9).
14
5. Hose clamp
6. Fuel tank connection
7. Spring
8. Locknut