Toro 03410TE Operator's Manual page 28

Maintenance
CAUTION
Be careful when lapping the reel because con-
tact with the reel or other moving parts can
result in personal injury.
CAUTION
Under no circumstances use a short-handled
paint brush. The 29-9100 handle assembly or
individual parts are available from your local
authorized TORO distributor.
Cutting Unit Set Up and Adjustment
SET HEIGHT OF CUT AND LEVEL
THE REAR ROLLER
(Floating Cutting Unit)
1. Position the cutting unit on a flat level table or
board.
2. Slightly loosen (crack) the nut securing each roller
bracket to the angle bracket.
3. Adjust the support capscrew to achieve a 1-inch ±
1
⁄ inch dimension between the height-of-cut sup-
16
port and the front roller bracket (2 places).
4. Adjust the support capscrew to achieve
1
⁄ inch dimension between the height-of-cut sup-
16
port and the rear roller bracket (2 places).
5. Remove the hairpin cotters securing the rear
height-of-cut pins and reinstall in the
28
MODEL AND SERIAL NUMBER
The mower has two identification numbers: a model
number and a serial number. The two numbers are
stamped into a plate that is riveted to the frame at the
rear of the mower. In any correspondence concerning
the mower, supply the model and serial numbers to
assure that correct information and replacement parts are
obtained.
Note: Do not order by reference number if a parts cata-
log is being used; use the part number.
To order replacement parts from an Authorized TORO
Service Dealer, supply the following information:
1. Model and serial numbers of the mower.
2. Part number, description and quantity of part(s)
desired.
5
⁄ inch ±
8
6.
1
⁄ -inch set-
2
ting as indicated on height-of-cut plate.
Figure 38
1. Roller bracket
2. Angle bracket
3. Height-of-cut pin
4. Support capscrew
5. Locknuts
Remove the hairpin cotters securing the front
height-of-cut pins and reinstall in the
1
⁄ -inch set-
4