Lubrication; Greasing The Bearings, Bushings, And Pivots - Toro 02750 Operator's Manual

Lubrication

Greasing the Bearings,
Bushings, and Pivots
Service Interval: Before each use or daily
Every 50 hours
Lubricate all grease fittings for the bearings and bushings
with No. 2 general-purpose, lithium-based grease. Lubricate
1. – Grease daily
2. – Grease daily (if fitted)
bearings and bushings immediately after every washing,
regardless of the interval listed.
Replace any damaged grease fittings.
Grease all cutting unit grease points and inject sufficient
grease such that you can see clean grease escaping from the
roller end caps. This provides visible evidence that the roller
seals have been purged of grass and debris and will ensures
maximum working life.
The grease-fitting locations and quantities are as follows:
Figure 32
3. – Grease every 50 hours (weekly)
33