Transport Latches; Adjustable Steering Column; Differential Lock; Forward Travel Speed Backstop Lever - Toro 02750 Operator's Manual

Transport Latches

Always raise the cutting units to the transport position and
secure with the transport latches and safety locks when
traveling between work areas

Differential Lock

WARNING
Do not engage the differential lock at high speed.
The turning circle will increase with the differential
lock engaged.
Engage the differential lock to increase tractive effort. Only
engage the differential lock at slow speeds
operate while the machine is moving forward and reverse.
To engage the differential lock, press the differential
lock pedal. To disengage the differential lock, release the
differential lock pedal.
Note: The differential lock is effective only when W
is selected.

Forward Travel Speed Backstop Lever

Use the backstop lever to limit the movement of the forward
pedal for accurate forward travel speed and to limit the clip
rate required (Figure 4).
Move the lever forward to increase the travel speed setting
and rearward to decrease it.
Note: This is not a cruise-control device. Releasing the
forward travel pedal will allow it to return to neutral.
(Figure 5).
G014548
Figure 5
(Figure 4). It will
Cutting Unit Drive Switch
Always put the cutting unit drive switch in the O
when traveling between work areas.

Adjustable Steering Column

WARNING
Never operate the machine without first checking
that the steering column adjuster mechanism is
in good working order and that, once adjusted
and locked, the steering wheel remains securely in
position.
Only adjust the steering wheel and steering column when the
machine is at a standstill with the parking brake engaged.
To adjust the angle of the steering wheel, move the lever
down, adjust the angle, and release the lever
To adjust the height of the steering column, move the lever
up, adjust the height, and release the lever
1. Adjust the angle of the
steering wheel.
2. Adjust the height of the
steering column.
ORK
15
FF
(Figure
(Figure 6).
Figure 6
3. Lever
position
6).