Adjusting The Height-Of-Cut; Controlling The Position Of An Individual Cutting Unit; Dual Lift Configuration Control - Toro 02750 Operator's Manual

Adjusting the Height-of-Cut

Refer to your cutting units Operator's Manual to adjust the
height-of-cut.
Controlling the Position of an
Individual Cutting Unit
The cutting units may be raised or lowered independently
using the bank of 3 lift-control levers.
1. To lower the cutting units, operate the lift-control
levers in a downward direction and release
Note: The cylinder drive will engage when the cutting
units are approximately 300 mm (11.8 inches) above
ground level. The cutting units are now in 'float' mode
and will follow the ground contours.
Important: The lift-control levers must be locked
in position 1 while moving. Do not mow with the
lift control levers in position 2.
1. Position 1—down/float
2. Position 2—neutral
3. Position 3—raise
Note: The lift levers will control different cutting
units depending on the lift configuration mode; refer
to Dual Lift Configuration Control (page
2. To raise the cutting units, operate the lift-control levers
in an upward direction and hold in position 3.
Note: If the cutting unit drive switch is in the O
position, the cylinder drive will disengage when the
cutting units are approximately 300 mm (11.8 inches)
above ground level.
3. Release the lift-control switches when the cutting units
are at the required height.
Note: The control switches will automatically return
to position 2 and the arms are hydraulically locked into
position.
(Figure
Figure 26
4. Left lift lever
5. Center lift lever
6. Right lift lever
25).

Dual Lift Configuration Control

The dual lift configuration control function enables the lift
controls to be used in the following ways
26).
1. 5-gang mode
2. 3/5-gang mode
3. Left lift lever
5-gang mode:
•
The left lift lever controls the left wing cutting unit.
•
The center lift lever controls the left front, center, and
right front cutting units.
•
The right lift lever controls the right wing cutting unit.
3/5-gang mode:
•
The left lift lever controls the left wing and left front
cutting units.
•
The center lift lever controls the center cutting unit.
•
The right lift lever controls the right wing and right front
cutting units.
N
3/5-gang mode with left and right wing cutting units
locked in transport position:
•
The left lift lever controls the left front cutting unit.
•
The center lift lever controls the center cutting unit.
•
The right lift lever controls the right front cutting unit.
25
(Figure 27):
Figure 27
4. Center lift lever
5. Right lift lever