Table of Contents
Advertisement
Motion Control Linkage - Remove and
Replace
1.
Remove the 6 bolts securing the console to the
rear frame assembly. Then, carefully lower the
console to gain access to the motion control
linkage (Figure 71).
Figure 71
2.
Remove the electrical plug from the neutral switch
(Figure 72).
Figure 72
3.
Remove the motion control handle.
4.
Remove the pin from the clevis on the control
lever centering rod (Figure 73).
Mid-Mount Z Service Manual
5.
Remove the control link from the bell crank
(Figure 73).
(A) Clevis Pin
(B) Control Rod
6.
Disconnect the steering dampening cylinder from
1023-014
the bell crank.
7.
Remove the bolts securing the bell crank inside
bearing (Figure 73).
8.
Remove the bolt securing the bell crank outside
bearing (Figure 74).
1023-018
CHASSIS
A
B
Figure 73
(C) Inner Bearing Bolts
Figure 74
C
1023-013
1023-019
5 - 1
Advertisement
Table of Contents
