Power Flush - Graco GX series Operation, Parts

Cleanup
ti27232a
16. Turn ON/OFF switch to OFF position.
17. Clean filter. See Cleaning Insta-
™
Clean Fluid Filter, page 28.
18. Fill unit with Pump Armor
Storage, page 29.

Power Flush

(GX 21, Water-based materials Only)
Power flushing is a faster method of flushing.
It can only be
water-based coatings.
1. Perform Pressure Relief Procedure,
page 13.
2. Remove spray tip and tip guard assem-
bly from gun and place in waste pail.
3. Place empty waste and paint pails side
by side.
24
™
fluid. See
used after spraying
ti27153a
4. Lift suction tube and drain tube from
paint pail. Let paint drain into the pail.
5. Place suction and drain tube in waste
pail.
6. Turn Pressure Control knob to the
Prime/Clean setting.
7. Screw power flush attachment valve to
garden hose. Close valve.
8. Turn on water. Open valve. Rinse paint
off suction tube, drain tube and inlet
strainer then close valve.
ti27 7155a
ti27156a
3A3212C