For use with non-flammable polyurethane foams, two-component coating systems
(polyureas), and some two-component epoxy systems. for professional use only.
not for use in explosive atmospheres.
3500 psi (24 mpa, 240 bar) maximum working pressure
125 psi (9 (42 pages)
Electric-hydraulic airless paint sprayer 3000 psi 210 bar maximum working pressure, provides 1 gpm at 1000 psi 70 bar (28 pages)
Summary of Contents for Graco GUSMER GX-7A
Page 1
Instructions - Parts 296897 Trigger Valve Rebuild Kit 311358C To replace spray gun trigger valve spring and o-rings. For professional use only. Important Safety Instructions Read all warnings and instructions in this manual and in your gun manual. Save these instructions. Model GX-7A, GX-7 400, GX-7 DI, and GX-8 Spray Guns, see page 2 Model GAP PRO and Long Shot Spray Guns, see page 3...
Page 2
Model GX-7A, GX-7 400, Ref. No. Part No. Description GX-7 DI, and GX-8 Spray Guns 295442 SPRING 111450 O-RING; fluoroelastomer 106555 O-RING; fluoroelastomer 118665 GREASE Before beginning, follow the Pressure Relief Procedure in your separate gun instruction See O-ring Identification Table on page 4 for manual.
Page 3
Model GAP PRO and Long Shot Ref. Spray Guns No. Part No. Description 295442 SPRING 118665 GREASE 112085 O-RING; fluoroelastomer C20988 O-RING; fluoroelastomer Before beginning, follow the Pressure Relief Procedure in your separate gun instruction See O-ring Identification Table on page 4 for manual.
Page 4
O-ring Identification Table O-ring Identification Table This table lists the dimensions of the o-rings used by all of the trigger valve rebuild kits from the largest to the smallest. Ref. Outside Inside Part No. Diameter Diameter 106555 0.504 in. 0.364 in. 112085 0.441 in.
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.