Related Manuals for PTN MUH66TP-N
Summary of Contents for PTN MUH66TP-N
- Page 1 User Manual MUH66TP-N 4K HDBaseT 6x6 Matrix Switcher All Rights Reserved Version: MUH66TP-N_2015V1.1 www.PTN-electronics.com...
- Page 2 Any other trademarks mentioned in this manual are acknowledged as the properties of the trademark owner. No part of this publication may be copied or reproduced without the prior written consent of PTN Electronics Limited. FCC Statement This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
-
Page 3: Safety Precautions
Unplug the power cord when left unused for a long period of time. Information on disposal for scrapped devices: do not burn or mix with general household waste, please treat them as normal electrical wastes. PTN Electronics Limited www.PTN-electronics.com... -
Page 4: Table Of Contents
1. Introduction ......................... 1 1.1 Introduction to the MUH66TP-N ................ 1 1.2 Features ......................1 1.3 Package List ...................... 1 2. Product Appearance of the MUH66TP-N ..............2 2.1 Front Panel ......................2 2.2 Rear Panel ......................3 3. System Connection ..................... 5 3.1 System Applications .................. - Page 5 4.4.2 GUI for TCP/IP control ................26 4.4.3 GUI Update.................... 30 4.5 Firmware Update via USB ................31 5. Specification ......................32 6. Panel Drawing ......................33 7. Troubleshooting & Maintenance ................34 8. After-sales Service ....................36 PTN Electronics Limited www.PTN-electronics.com...
-
Page 6: Introduction
1. Introduction 1.1 Introduction to the MUH66TP-N MUH66TP-N is a professional 6x6 HDBaseT Matrix Switcher that accommodates 6 HDMI IN (4k signal at max), 6 auxiliary audio IN, 6 IR IN. Select HDMI input by front panel buttons, IR, RS232, or GUI. The selected source is delivered to HDMI Output 1~3 (for HDMI input 1~3) &... -
Page 7: Product Appearance Of The Muh66Tp-N
18 x Pluggable Terminal Blocks 1 x User manual Notes: Confirm if the product and the accessories are all included, if not, please contact with the dealers. 2. Product Appearance of the MUH66TP-N 2.1 Front Panel INPUTS MENU SYSTEM MONITOR... -
Page 8: Rear Panel
IR signal sent from the far-end receivers connected to the ① INPUTS HDBaseT ports. These IR OUT sockets make up an IR matrix with the IR IN sockets on the far-end receivers, and all can be PTN Electronics Limited www.PTN-electronics.com... - Page 9 When controlled by ② OUTPUTS HDBaseT receiver, the communication protocol must be the same with the MUH66TP-N’s. AUDIO: stereo audio output ports, 6 in total HDMI: Local HDMI output ports for HDMI Inputs 1~3, synchronously switched with HDBaseT Output 1~3...
-
Page 10: System Connection
TPHD402PR Laptop 3.4 Connection Procedure 1) Connect HDMI sources (e.g. DVD) to HDMI inputs of the MUH66TP-N with HDMI cables. 2) Connect auxiliary audio sources to the AUDIO IN ports with audio cables. 3) Connect HDBaseT receivers (e.g. TPHD402PR) to the HDBaseT Output ports with twisted pair. -
Page 11: Connection With Tphd402Pr
MUH66TP-N or far-end receivers. RS232 signal can be transmitted bi-directionally between MUH66TP-N and far-end receivers. 7) MUH66TP-N can collect IR signal sent by the included IR remote via its built-in IR sensor or through external IR receiver connected to the IR IN/ IR EYE/ IR ALL IN port. -
Page 12: System Operations
Example: Convert input 1 to all outputs Note: Indicators of the pressed buttons will blink green for three times if the conversion is done, then it will be off. If the conversion failed, they will be off immediately. PTN Electronics Limited www.PTN-electronics.com... -
Page 13: Edid Management
4K HDBaseT 6x6 Matrix Switcher 4.1.2 EDID Management MUH66TP-N features EDID management to maintain compatibility between all devices. It can be controlled via EDID learning and EDID invoking. EDID Learning (from output): One input port learns the EDID data of one output port Operation: Press ―EDID‖, ―INPUTS‖+―OUTPUTS‖+―ENTER‖. -
Page 14: Inquiry
Y means the output signal is with output is with HDCP, N means not. HDCP Check the Use button to check the 6 output resolution output resolutions separately. Output check Press any output button to check its corresponding input. PTN Electronics Limited www.PTN-electronics.com... -
Page 15: Clear Operation
―ENTER‖ to carry it on. When you press it, the matrix will return to the previous status. 4.2 IR Control By using IR & HDBaseT transmission technology, the MUH66TP-N has some functions as follows: 1) Control far-end output device from local. -
Page 16: Usage Of Ir Remote
RS232, and 1 AUDIO outputs, and channel 1~3 have HDMI outputs. Note: With this IR remote, MUH66TP-N can be controlled by the built-in IR, the extended IR receiver connected to the ―IR EYE‖/‖IR ALL IN‖ and the IR receiver on the far-end receiver. -
Page 17: Ir Operations
Sending command (reference to 4.3 RS232 Control): [x1]R[x2]. x1: Corresponding to the 6 IR OUT ports of the matrix, the IR transmitter connected to this port can be placed at IR receiving area of output device or MUH66TP-N itself. - Page 18 Control far-end output device from local Connect an IR receiver with IR carrier to the IR IN port of MUH66TP-N, users can control far-end output displayer via its IR remote from local. In that case, the IR signal is transferred via twisted pair. Only the corresponding IR OUT port can emit control signals to the remote display.
- Page 19 User can control local source devices with their IR remote from remote too. When using, the IR signal received by the HDBaseT receiver will be transmitted to the corresponding IR OUT port of the MUH66TP-N. See below: IR OUT IR OUT...
-
Page 20: Rs232 Control
Uninstallation Delete all the control software files in corresponding file path. 4.3.3 Basic Settings Firstly, connect MUH66TP-N with an input device and an output device. Then, connect it with a computer which is installed with RS232 control software. Double-click the software icon to run this software. -
Page 21: Rs232 Communication Commands
Unlock the front panel buttons on the /%Unlock; System Unlock! Matrix. /^Version; Inquire the version of firmware VX.X.X Turn off the feedback command from the /:MessageOff; com port. It will only show simple words /:MessageOff; like ―SWITCH OK!‖. PTN Electronics Limited www.PTN-electronics.com... - Page 22 Transfer the AV and IR signal from input channel [x1] to one or several output AV: X1-> X2 [x1]B[x2]. channels ([x2], separate output channels (X1/X2=1~6) with comma). Check the I/O connection status of output AV: Y-> X Status[x]. (X=1~6, Y=1~6) PTN Electronics Limited www.PTN-electronics.com...
- Page 23 X=7, enable all the 6 ports. Disable HDMI audio output of port x. DigitAudio OFF with DigitAudioOF X=1, 2, 3, 4, 5, 6, disable this port. F[x]. X=7, disable all the 6 ports. x=1~6 or ALL PTN Electronics Limited www.PTN-electronics.com...
- Page 24 E & K are for port 5. F & L are for port 6. ② X is for bound rate, its value ranges from 1 to 7 (1--2400, 2--4800, 3--9600, 4--19200, 5--38400, 6—57600, 7--115200) ③ ***** is for data (max 48 Byte) PTN Electronics Limited www.PTN-electronics.com...
- Page 25 Operations will be canceled after 10 seconds. Please cut off all connections of HDBaseT ports. Set the EDID data of input port [x] to built-in EDID No.[y]. EDID/[x]/[y]. EDID/[x]/[y] [y]=1~6, correspond to the 6 embedded EDID data PTN Electronics Limited www.PTN-electronics.com...
- Page 26 Check the command sent by port 5 when Port 5:data when %9955. PWON. PWON Check the command sent by port 6 when Port 6:data when %9956. PWON. PWON Check the command sent by port 1 when Port 1:data when %9941. PWOFF. PWOFF PTN Electronics Limited www.PTN-electronics.com...
- Page 27 Connect N Y Y Y %9971. Check the connection status of the inputs. Connect N Y 1 2 3 4 Check the connection status of the Connect N Y Y Y %9972. outputs. Connect N Y PTN Electronics Limited www.PTN-electronics.com...
- Page 28 2) In above commands, ―[‖and ―]‖ are symbols for easy reading and do not need to be typed in actual operation. 3) Please remember to end the commands with the ending symbols ―.‖ and ―;‖. 4) Type the command carefully, it is case-sensitive. PTN Electronics Limited www.PTN-electronics.com...
-
Page 29: Rs232 Control Modes
4K HDBaseT 6x6 Matrix Switcher 4.3.5 RS232 Control Modes To control the MUH66TP-N, you need to connect its 9 pin female RS232 port to a PC’s RS232 port, or you can just connect any one of the HDBaseT receiver’s RS232 port with PC (RS232 command can be transmitted to the MUH66TP-N via the twisted pair). -
Page 30: Bi-Directional Rs232 Control
RS232 AUDIO RS232 AUDIO Matrix INPUT INPUT INPUT OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 OUTPUT 5 OUTPUT 6 3rd party TPHD402PR HDBT IN HDMI OUT IR IN IR OUT RS232 Control far-end device from local PTN Electronics Limited www.PTN-electronics.com... -
Page 31: Tcp/Ip Control
8080. IP & Gateway can be changed as you need, Serial Port cannot be changed. Controlled by Single PC Connect a computer to the TCP/IP port of the MUH66TP-N, and set its network segment to the same as the MUH66TP-N’s. - Page 32 Controlled by PC(s) in LAN Connect MUH66TP-N, a router and several PCs to setup a LAN (as shown in the following figure). Set the network segment of MUH66TP-N to the same as the router’s, then PCs within the LAN are able to control MUH66TP-N.
-
Page 33: Gui For Tcp/Ip Control
4K HDBaseT 6x6 Matrix Switcher Step4. Set the PC’s network segment to the original ones. Step5. Connect the MUH66TP-N and PC(s) to the router. PC(s) within the LAN is able to control the MUH66TP-N asynchronously. Then it’s able to control the device via GUI. - Page 34 If there is any modification, press Save to restore the settings, or press Cancel to withdraw. Interface: Set title bar label, LCD readout, and button labels, press Save to save the settings Configuration: Set HDCP Cmpliance status for every input, and manage EDID. See the screenshot below: PTN Electronics Limited www.PTN-electronics.com...
-
Page 35: Gui Update
Note: Log in as user access main interface only. 4.4.3 GUI Update GUI for MUH66TP-N supports online update in http://192.168.0.178:100. Type the username and password (the same as the GUI log-in settings, modified password will be available only after rebooting) to log in the configuration interface. After that, click... -
Page 36: Firmware Update Via Usb
Select the desired update file and press Apply, it will start upgrading then. 4.5 Firmware Update via USB MUH66TP-N boasts a USB port for online firmware upgrade on the front panel. Follow these steps to upgrade firmware: Step1. Copy the upgrade software and the latest upgrade file (.bin) to PC. -
Page 37: Specification
6 IR OUT (green and red) 6 IR IN (black) 1 IR EYE (black) Control Ports Panel Control Front panel buttons 1 IR ALL IN (black) 1 TCP/IP (female RJ45) 1 RS232 (9 pin female) 6 RS232s (3-pin PTN Electronics Limited www.PTN-electronics.com... -
Page 38: Panel Drawing
Works with In-built web GUI Control General Power Power 80W （full load） 100V~240V AC Supply Consumption Reference Temperature -10 ~ +40℃ 10% ~ 90% Humidity Dimension 437 x 87.8 x 380 mm Weight 5.3Kg (W*H*D) 6. Panel Drawing PTN Electronics Limited www.PTN-electronics.com... -
Page 39: Troubleshooting & Maintenance
Change for an IR receiver to IR IN/ IR ALL IN port is with carrier. not with carrier Power Indicator remains off Fail loose power Check whether the cables when powered on connection are connected correctly PTN Electronics Limited www.PTN-electronics.com... - Page 40 Send it to authorized by RS232 / IR remote / been broken. dealer for repairing. front panel buttons If your problem persists after following the above troubleshooting steps, seek further help from authorized dealer or our technical support. PTN Electronics Limited www.PTN-electronics.com...
-
Page 41: After-Sales Service
If there appear some problems when running the device, please check and deal with the problems reference to this user manual. 1) Product Limited Warranty: PTN warrants that its products will be free from defects in materials and workmanship for three years, which starts from the first day the product leaves warehouse (check the SN mark on the product). - Page 42 4K HDBaseT 6x6 Matrix Switcher PTN Electronics Limited www.PTN-electronics.com...
- Page 43 4K HDBaseT 6x6 Matrix Switcher PTN Electronics Limited www.PTN-electronics.com...
- Page 44 PTN Electronics Limited Tel: +86-755-2846 1819 Fax: +86-755-8471 7796 Email: info@PTN-electronics.com Website: www.PTN-electronics.com...
Need help?
Do you have a question about the MUH66TP-N and is the answer not in the manual?
Questions and answers