Adjusting The Anti-Scalp Rollers - Toro 74295 Operator's Manual

Figure 22
1. Height of cut lever
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 22).
3. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired and,
insert the pin (Figure 22).
4. Move the lever to the selected height.
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
Adjusting the Outer Roller
1. Disengage the PTO, move the motion control levers
to the neutral locked position, and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, remove the flange
nut, bushing, spacer, and bolt (Figure 23).
2. Pin
1. Outer roller
2. Spacer
3. Bushing
4. Select a hole so that the outer roller is positioned
to the nearest corresponding height-of-cut desired
(Figure 23).
5. Install the outer roller, bushing, spacer, bolt, and
nut (Figure 23).
6. Torque the bolt to 40 to 45 ft-lb (54 to 61 N⋅m).
Adjusting the Center Rollers
1. Disengage the PTO, move the motion control levers
to the neutral locked position, and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, remove the flange
nut, bushing, and bolt (Figure 24).
22
Figure 23
4. Bolt
5. Nut