Think Safety First - Toro 74295 Operator's Manual

WARNING
There is no rollover protection when the roll bar
is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Lower the roll bar only when
absolutely necessary.
1. Remove the hairpin cotter pins and remove the two
pins (Figure 10).
2. Lower the roll bar to the down position. There are
two down positions. See Figure 9 for the positions.
3. Install the two pins and secure them with the hairpin
cotter pins (Figure 10).
Figure 9
1. Full down position
Important: Ensure that the rear part of the
seat is secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter pins
and remove the two pins (Figure 10).
5. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 10).
Important: Always use the seat belt with the
roll bar in the raised position.
2. Down position with bagger
installed
1
3
4
1. Roll bar
2. Raised position

Think Safety First

Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
DANGER
Operating on wet grass or steep slopes can cause
sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death or
drowning.
There is no rollover protection when the roll bar
is down.
Always keep the roll bar in the raised and locked
position and use the seat belt.
Read and follow the rollover protection instructions
and warnings.
To avoid loss of control and possibility of rollover:
• Do not operate near drop-offs or near water.
• Do not operate on slopes greater than
15 degrees.
• Reduce speed and use extreme caution on
slopes.
• Avoid sudden turns or rapid speed changes.
16
2
G004955
Figure 10
3. Pin
4. Hairpin cotter pin