Specifications - Toro 74942TE Operator's Manual

Blade-control Switch (PTO)
The blade-control switch (PTO) is used to engage the electric
clutch and drive the mower blades. Pull the switch up to
engage the blades and release. To disengage the blades,
push the blade-control switch (PTO) down or move a
motion-control lever into the neutral-lock position.
Ignition Switch
This switch starts the engine and has 3 positions: Start, Run,
and Off.
Motion-control Levers
Use the motion-control levers to drive the machine forward,
reverse, and turn either direction.
Neutral-lock Position
The neutral-lock position is used with the safety-interlock
system and to determine neutral position.
Fuel-shutoff Valve
Close the fuel-shutoff valve (under the seat) when
transporting or storing the machine.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Specifications

Note: Specifications and design are subject to change
without notice.
Width:
Without Mower Deck
With Mower Deck
Length:
Roll Bar—Up
Roll Bar—Down
Height:
Roll Bar—Up
179.1 cm (70.5 inches)
152 cm (60 inch) Deck
134.6 cm (53.0 inches)
168.4 cm (66.3 inches)
152 cm (60 inch) Deck
221.6 cm (87.25 inches)
226.0 cm (88.95 inches)
Roll Bar—Down
118.9 cm (46.8 inches)
Weight:
Model
60 inch Mower Decks
16
Weight
590 kg (1301 lb)