Stopping The Machine; Adjusting The Height Of Cut - Toro 74942TE Operator's Manual

Figure 25

Stopping the Machine

To stop the machine, move the motion-control levers to
neutral and move them to the locked position, disengage the
power take off (blade-control switch (PTO), and turn the
ignition key to the off position.
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake in Operation. Remember to remove
the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has two positions and is used with the
deck-lift pedal. There is a lock position and a unlock position
for the transport position. The transport lock is used with the
deck-lift pedal. Refer to Figure 26
G008953
26
Figure 26
Transport Lock Positions
1. Transport lock
2. Lock position—mower
deck will lock into transport
position
3. Unlock position—does not
lock the mower deck into
transport position