Toro 03674 Operator's Manual page 20

Power Point
The power point is a 12 V power supply for electronic devices
(Figure 25).
Figure 25
1. Power point
Cutting-Unit-Power Disconnect
Before installing, removing, or working on the cutting
units, disconnect the cutting units from the power supply
by separating the cutting-unit-power-disconnect connector
(Figure 26), located under the seat. Plug the connector back
in before operating the machine.
1
Figure 26
1. Power-disconnect connector
CAUTION
If you do not disconnect the power to the cutting
units, someone could accidentally start the cutting
unit, causing serious injury to hands and feet.
Always separate the cutting-unit-power-disconnect
connectors before working on the cutting units.
Using the InfoCenter LCD Display
The InfoCenter LCD display shows information about your
machine such as the operating status, various diagnostics
and other information about the machine
are multiple display screens on the InfoCenter. You can
switch between the screens, at any time, by pressing any of
the InfoCenter buttons and then selecting the appropriate
directional arrow.
1. Indicator light
2. Right button
•
Left Button, Menu Access/Back Button— Press this
button to access the InfoCenter menus. You can use it to
back out of any menu you are currently using.
•
Middle Button— Press this button to scroll down menus.
•
Right Button— Press this button to open a menu where a
right arrow indicates additional content.
Note: The purpose of each button may change depending
on what is required at the time. Each button is labeled with
an icon displaying its current function.
g027134
20
1
4
3
Figure 27
3. Middle button
4. Left button
(Figure 27). There
g020650
2