Servicing The Engine Oil And Filter; Servicing The Fuel System - Toro 30410 Operator's Manual

Traction unit
Hide thumbs Also See for 30410:
Table of Contents

Advertisement

6. Insert the new filter properly into the air cleaner body.
Make sure that the filter is sealed properly by applying
pressure to the outer rim of the filter when installing it.
Do not press on the flexible center of the filter.
7. Install the cover and secure the latch. Make sure that the
cover is positioned with the TOP side up.
8. Reset the indicator (Fig. 44) if it shows red.
Servicing the Engine Oil and
Filter
Change the oil and filter initially after the first 50 hours of
operation; thereafter change the oil and filter every 100
hours.
1. Remove either drain plug (Fig. 47) and let the oil flow
into a drain pan. When the oil stops, install the drain
plug.
1
Figure 47
1. Engine oil drain plug
2. Remove the oil filter (Fig. 48). Apply a light coat of
clean oil to the new filter seal before screwing it on. Do
not overtighten.
1
Figure 48
1. Engine oil filter
3. Add oil to the crankcase; refer to Checking the Engine
Oil, page 15.

Servicing the Fuel System

Danger
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A fire
or explosion from fuel can burn you and others
and can cause property damage.
Use a funnel and fill the fuel tank outdoors, in
an open area, when the engine is off and is cold.
Wipe up any fuel that spills.
Do not fill the fuel tank completely full. Add fuel
to the fuel tank until the level is 1/4 to 1/2 in. (6
to 13 mm) below the bottom of the filler neck.
This empty space in the tank allows the fuel to
expand.
Never smoke when handling fuel, and stay away
from an open flame or where fuel fumes may be
ignited by a spark.
Store fuel in a clean, safety-approved container
and keep the cap in place.
Fuel Tank
Drain and clean the fuel tank every 800 hours. Also, drain
and clean the tank if fuel system becomes contaminated or
if the machine will be stored for an extended period of
time. Use clean fuel to flush out the tank.
Fuel Lines and Connections
Check the fuel lines and connections every 400 hours or
yearly, whichever comes first. Inspect them for
deterioration, damage, or loose connections.
Water Separator
Drain water or other contaminants from the water separator
(Fig. 49) daily.
1. Place a clean container under the fuel filter.
2. Loosen the drain plug on the bottom of the filter
canister (Fig. 49). Tighten the plug after draining.
38

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 4000-d

Table of Contents