Table of Contents
Advertisement
Important
The damper link length should never be
adjusted. The length between the hole centers should be
5-3/8 in. (13.7 cm).
1
Figure 18
1. Damper link
Figure 19
Adjusting the Skids
The skids should be mounted in the lower position when
operating in height of cuts greater than 2-1/2 inches
(64 mm) and in the higher position when operating in
height of cuts lower than 2-1/2 inches (64 mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Fig. 20).
Figure 20
1. Skid
Adjusting the Cutting Unit
Rollers
1. Remove the capscrew and nut securing the gage wheel
to the cutting unit brackets (Fig. 21).
1
Figure 21
1. Gage wheel
2. Align the roller and spacer with the top holes in the
brackets and secure them with the capscrew and nut.
22
1
Advertisement
Table of Contents
