Checking The Rear Axle Lubricant; Checking The Rear Axle Gear Box Lubricant - Toro 30410 Operator's Manual

Figure 6
1. Check/drain plug
2. Remove the plug on the planetary (Fig. 6) and check the
plug on the back side of the brake (Fig. 7). Oil should
be at the bottom of the check plug hole on the back side
of the brake.
1
2
Figure 7
1. Brake housing
1
2. Check plug
18
3. Add gear oil to the hole in the planetary, if necessary, to
bring the oil up to the proper level. Install the plug.
4. Repeat steps 1–3 on the opposite gear assembly.
Checking the Rear Axle
Lubricant
The rear axle is shipped from the factory filled with SAE
85W-140 wt. gear lube. Check the oil level before the
engine is first started and every 400 hours thereafter. The
capacity is 80 oz. (2.4 l). Visually inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove a check plug from one end of the axle (Fig. 8)
and make sure that the lubricant is up to the bottom of
the hole. If the level is low, remove the fill plug (Fig. 8)
and add enough lubricant to bring the level up to the
bottom of the check plug holes.
1
Figure 8
1. Check plug
Checking the Rear Axle Gear
Box Lubricant
The gear box is shipped from the factory filled with SAE
85W-140 wt. gear lube. Check the oil level before the
engine is first started and every 400 hours thereafter. The
capacity is 16 oz. (0.5 l). Visually inspect for leaks daily.
1. Position the machine on a level surface.
2
2. Fill plug