Table of Contents
Advertisement
Fuses
There are 5 fuses in the electrical system. They are located
below the operators control panel (Fig. 75 and 76).
1
Figure 75
1. Fuses
Figure 76
Adjusting the Transport Latch
If the transport latch (Fig. 77) has to be adjusted, adjust as
follows:
1. Raise the front cutting unit fully off of the floor, set the
parking brake, and stop the engine. Remove the ignition
key.
2. Loosen flange nuts securing latch arm pivot to traction
unit frame.
3. Move latch arm pivot in or out until rubber cushion of
adjustment screw is centered under deck latch. Tighten
flange nuts.
3
1. Latch arm pivot
2. Adjustment screw
3. Deck latch
4. Clearance between adjustment screw rubber (Fig. 78)
cushion and deck latch should be .125". If an
adjustment is required, loosen nut on adjustment screw,
adjust screw until required clearance is attained and
tighten nut.
2
.125"
1. Adjustment screw
Pivoting (Tilting) the Front
Cutting Unit Upright
Note: Although not needed for normal maintenance
procedures, the front cutting unit can be pivoted (tilted) to
an upright position (Fig. 79). Should you desire to tilt the
cutting unit, proceed as follows:
49
2
Figure 77
1
Figure 78
2. Deck latch
1
Advertisement
Table of Contents
