Miele KFN 29683 D Operating And Installation Instructions page 95

 Remove cover  and refit on the op-
posite side.
 Turn holder  through 180° and
screw it into position in the two op-
posite slots in the hinge plate.
 Secure hinge plate  on the opposite
side, starting with screw  in the
middle at the bottom.
 Then screw in the other two
screws .
 Insert hinge pin  complete with
washer and adjusting foot.
Important. The lug on the hinge pin
must point to the back again.
Changing the door hinging
Changing the middle hinge
plate over
 Pull off cover .
 Unscrew hinge plate  with the pro-
tective film underneath.
 Turn hinge plate  through 180° and
screw it with the protective film into
position on the opposite side.
The protective film protects the appli-
ance housing from damage.
 Turn grey plastic cover  through
180° and refit it in the hinge plate.
Tip: Plastic cover  fits over the pro-
truding bearing bush so that this is
covered from underneath and from the
side.
 Turn cover  through 180° and refit it
on the opposite side.
95