STIEBEL ELTRON WWK 300 A Operation And Installation
Hide thumbs
Also See for WWK 300 A:
- Operation & installation manual (20 pages) ,
- Operating and installation instructions (16 pages) ,
- Operation and installation (20 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for STIEBEL ELTRON WWK 300 A
Summary of Contents for STIEBEL ELTRON WWK 300 A
- Page 1 OPERATION AND INSTALLATION DHW HEAT PUMP » WWK 300 A » WWK 300 AH...
-
Page 2: Table Of Contents
Operation with active defrost fea- operating and installation instructions. ture The appliance may be used by WWK 300 A and WWK 300 AH ���� 3 children aged 8 and up and per- Maintenance and cleaning �������� 4 sons with reduced physical, sensory or mental capabilities or a lack of experi- Troubleshooting by the user ������... -
Page 3: Operating Instructions For Users
This is the standard operating mode, frost feature fixtures used primarily for per- to which the limits of scope of the heat WWK 300 A and WWK 300 AH sonal hygiene. pump apply (see: Specification). To Subject to the relative humidity and the heat up the cylinder capacity of approx. -
Page 4: Maintenance And Cleaning
Maintenance and cleaning Troubleshooting by the user The device is generally maintenance free, No hot water with the exception of cleaning the con- Should you fail to obtain hot water at any densate drain and having an authorised time, you can take the following steps to contractor check the sacrificial anode (as remedy that situation. -
Page 5: Installation Instructions For Con
Installation instructions for contractors Regulations and standards Also observe the following: z The equipment type plate z The installation (water and electrical work) and commissioning, as well as z The specification the maintenance of this equipment, z Water installation must only be carried out by an autho- —... -
Page 6: Installation
Installation — In case of indoor installation and min. Where possible select an installation location that has limited exposure to ex- installation room volume, the room Transport treme rain or snow. temperature might be reduced by ap- To protect the equipment against prox. - Page 7 (Fig. 1, pos 12) and adjusted to a maximum of 500 kPa. If the ECV is re- quired, set PRV to a maximum of 420 kPa. WWK 300 A/WWK 300 AH: Fig. 3 Capacitor Electric booster heater (only for the WWK 300 AH)
-
Page 8: Power Supply
Power supply Commissioning Safety equipment and main- Only qualified electricians must carry out Only approved contractors may tenance the installation in accordance with these commission this equipment and instruct Only qualified contractors must carry out instructions. the owner in its use. the installation in accordance with these instructions. - Page 9 Protective anode Cleaning the evaporator On the system Maintaining the full output of the PLEASE NOTE: The sacrificial Safety valve (on-site) WWK 300 requires an occasional anode must be checked by a This valve opens when the water pressure professional cleaning of the evaporator. qualified contractor 12 months after exceeds the preset value of 0.7 MPa Clean the evaporator only with water...
-
Page 10: Specification
Specification WWK 300 AH WWK 300 A 227070 222422 Power consumption Power consumption at A15/W15-55 Power consumption, emergency/booster heater 1,69 Coefficient of performance (COP) Coefficient of performance at A15/W15-55 COPs to EN 255 Coefficient of performance to EN 255 3,19... -
Page 11: Operation With Active Defrost Fea
Operation with active de- frost feature Heating operation Defrost operation >P >P Fig. 4... -
Page 12: Wiring Diagrams
Wiring diagrams 2.9.1 WWK 300 A T< 14 13 11 10 -7°C/+3°C > T< gnye gnye L PE Operating capacitor Motor circuit switch Pressure limiter refrigerant circuit Compressor Thermostat heat pump Hoar frost temperature monitor Solenoid valve Solenoid valve Terminal mains... - Page 13 2.9.2 WWK 300 AH T< 14 13 11 10 -7°C/+3°C > T< gnye gnye L PE Capacitor Hoar frost temperature monitor Electric heating element (booster heater) Solenoid valve Temperature limiter electric heating element (booster Solenoid valve heater) Terminal mains Motor circuit switch Terminal heat pump Pressure limiter refrigerant circuit Ground compressor device...
-
Page 14: 2.10 Dimensions And Connections
2.10 Dimensions and connections WWK 300 AH WWK 300 A Entry electrical cables Cold water inlet Male thread DHW outlet Male thread T&P valve Female thread G 3/4 G 3/4 Condensate overflow Condensate drain Male thread G 3/4 G 3/4... -
Page 15: Guarantee
Guarantee The guarantee conditions of our German companies do not apply to appliances acquired outside of Germany. In countries where our subsidiaries sell our products a guarantee can only be issued by those subsidiaries. Such guarantee is only grant- ed if the subsidiary has issued its own terms of guarantee. No other guarantee will be granted. - Page 16 Who gives the warranty 8.2. you contact us within a reasonable time of discovering the The warranty is given by Stiebel Eltron (Aust) Pty Ltd problem with the unit; (A.B.N. 82 066 271 083) of 6 Prohasky Street, Port Mel- bourne, Victoria, 3207 (“we”, “us”...
- Page 17 -1.0 < LSI <0.8 (The LSI is a numeric value indicating whether water is scale form- The Stiebel Eltron warranty for the unit is in addition to any ing or corrosive. It factors in pH, total alkalinity, calcium rights and remedies you may have under the Australian hardness and water temperature);...
- Page 18 Sacrificial anode maintenance log PLEASE NOTE: The sacrificial anode must be checked by a qualified contractor 12 months after the unit has been installed and checked periodically thereafter as advised by the qualified contractor. Failure to do so may void your warranty. Date unit was installed 12 month sacrificial Completed...
- Page 20 Deutschland Verkauf Tel. 05531 702-110 | Fax 05531 702-95108 | info-center@stiebel-eltron.de STIEBEL ELTRON GmbH & Co. KG Kundendienst Tel. 05531 702-111 | Fax 05531 702-95890 | kundendienst@stiebel-eltron.de Dr.-Stiebel-Straße 33 | 37603 Holzminden Ersatzteilverkauf Tel. 05531 702-120 | Fax 05531 702-95335 | ersatzteile@stiebel-eltron.de Tel.
Need help?
Do you have a question about the WWK 300 A and is the answer not in the manual?
Questions and answers
Heat pump not heating water,what is the maximum refrigerant charge in Pasig R134a.
The maximum refrigerant charge for the STIEBEL ELTRON WWK 300 A heat pump using R134a is 0.9 kg.
This answer is automatically generated