Care And Maintenance - PizzaMaster PM 351ED Instructions For Installation, Use And Maintenance Manual

Care and Maintenance

Care and maintenance
A well maintained oven lasts longer and looks like new
for a long time. We recommend cleaning and servicing
your oven as follows:
Important!
• Do not use cleaning agents on the hearthstones. If
cleaning is necessary, use a clean damp cloth only.
• Do not use pressure-washing equipment to clean
the oven.
• Do not use abrasive materials like steel wool or
abrasive sponges to clean the glass in the oven
door. N.B. Before cleaning, the glass should be cool
enough (max 50 °C) to touch. Otherwise there is a
risk of cracking.
Daily maintenance and cleaning
1. Brush out and scrape out any bake residue or soot
in the oven chamber.
2. Clean the door-glass inside and outside using a
cloth moistened with water and glass-cleaning
agent.
3. Clean the outside of the oven using a cleaning agent
for stainless-steel surfaces.
Monthly maintenance and cleaning
1. First clean the oven's external stainless-steel sur-
faces. Then, if necessary, use a special cleaning and
polishing cloth for brushed stainless-steel surfaces.
IMPORTANT!
Your oven has surfaces of brushed stainless-steel.
Always apply the special cloth in the direction of the
grain.
2. Lubricate the door bushings with a high-temperature
oil lubricant.
Annual maintenance and cleaning
1. Lift out the hearthstones and vacuum-clean the
entire oven chamber.
IMPORTANT!
Be very careful to mark and put back the hearth-
stones exactly as they were. Each stone must be
returned to its original place with the same side
facing upward and turned in the same direction as
before.
Changing an oven lamp
1. Turn the oven off.
2. Loosen the lamp glass. (Stick a small screwdriver in
the small gap at the lamp glass short side and press
gentle to loosen the glass)
3. Take out the defective lamp.
IMPORTANT!
Take care not to touch the new lamp directly, for that
would reduce its service life.
4. Wear gloves or use a piece of paper to grasp and fit
the new lamp.
5. Fit back the lamp glass