The side on which the door opens can be
changed from the right side (as supplied) to
the left side if the installation site allows.
When reversing the door, the appliance
must not be connected to the power
source. Ensure that the plug is
removed from the power source.
Tools you will need:
8 mm socket driver
Putty knife or thin-blade screwdriver
8 mm wrench
Before you start, lay the refrigerator on its
back in order to gain access to the base.
You should rest it on soft foam packaging
or similar material to avoid damaging the
backboard of the refrigerator.
To reverse the door:
1 Stand the refrigerator upright. Open
the upper door. Take out all door
racks (to avoid damaging the racks)
and then close the door.
Reversing the Door
2 Open upper cover ① on top of the
refrigerator body from right side and
then remove the upper hinge cover
② and magnetic switch box ③.
3 Remove the corner cover.
4 Remove the screws ①, and remove
Be sure doors are set aside in a
secure position where they cannot
fall and cause personal injury, or
damage to the doors or handles.