Finding Information PLEASE READ AND SAVE THIS GUIDE Thank you for choosing Electrolux, the new premium brand in home appliances. Attach your sales This Use & Care Guide is part of our commitment to customer satisfaction and receipt to this product quality throughout the service life of your new refrigerator.
Electrical Information ... 5 Removing The Doors ... 6 Getting Through Narrow Spaces ... 6 Connecting The Water Supply ... 9 About Your Refrigerator’s Water Supply ... 9 Feature Overview ... 11 Understanding Features And Terms ... 11 Controls & Settings ... 12 Allowing Cooling Time Before Use ...
WARNING WARNING WARNING Please read all safety instructions before using your new Electrolux refrigerator. General Safety • Do not store or use gasoline, or other flammable liquids, near this or any other appliance. Read product labels for warnings regarding flammability and other hazards.
• Avoid connecting refrigerator to a Ground Fault Interruptor (GFI) circuit. IMPOR IMPOR IMPORT T T T T ANT IMPOR IMPOR To turn off power to your refrigerator, unplug the power cord from the wall outlet. Safety...
Removing The Doors GETTING THROUGH NARROW SPACES If your refrigerator will not fit through an entrance area, you can reduce its size by removing the doors. Check first by measuring the entrance. Required Tools You will need the following tools: Tools Necessary: ™...
Be sure doors are set aside in a secure position where they cannot fall and cause personal injury. To reinstall the refrigerator door, reverse the above steps. Once both doors are in place, also replace the top hinge cover. Removing The Doors...
Removing The Doors To remove the freezer door: 1 Detach the multi-wire cable connector located above the top hinge. Grasp both sides of the connector firmly and pull apart. 3 Detach the water tube from the connector located below the freezer door.
• A compression nut and ferrule (sleeve) for the water supply connection at the rear of your refrigerator. NOTE Electrolux Kit #53039117950, available from your dealer, provides all materials for a water supply installation, including 25 feet of copper tubing and full instructions.
Connecting The Water Supply To connect the water supply to the rear of your refrigerator: 1 Ensure that the refrigerator is not plugged in. 2 Flush the supply line until water is clear by placing the end of the copper tube in a sink or bucket and opening the shut-off valve.
UNDERSTANDING FEATURES AND TERMS Your Electrolux refrigerator is designed for optimal convenience and storage flexibility. Use the illustration below to familiarize yourself with product features and terminology. NOTE Features may vary according to model. Feature Overview...
Controls & Settings ALLOWING COOLING TIME BEFORE USE To ensure reliable food storage, allow your refrigerator and freezer to operate with the doors closed for 8 to 12 hours before placing food inside. During this cooling period, you do not need to adjust the controls, which are preset at the factory.
What To Do If The Temperature Displays Flash If ever you you see both temperature displays continuously flashing, it may indicate that the control system has detected a performance problem. Call your Electrolux service representative, who can interpret the flashing message.
Controls & Settings SYSTEM-MONITORING ALARMS Indicator Lights Alarm Reset Button Responding to Alarms (Audible Tones & Indicator Lights) Your refrigerator’s control system can convey the following information through audible tones and the alarm indicator lights. Alarm Indicator Audible Name Light...
The alarm system does not automatically reset if you disconnect and reconnect your refrigerator’s power cord. It can only be reactivated by pressing the Alarm Reset button. Once you disable the alarm system, you must again press and hold the Alarm Reset button for three more seconds to reset (activate) the alarm system.
IMPORT T T T T ANT IMPOR IMPOR The On/Off button only controls your refrigerator’s cooling system. Power to lights and other electrical components continues unless you unplug the power cord. You can disable the cooling system in your refrigerator by pressing the On/Off button located on the left side of the temperature control panel.
5 Lower the shelf and lock into position. Shelf Features Your refrigerator includes SpillSafe designed to catch and hold accidental spills. These shelves slide out for easy access to food and faster cleaning. Sliding shelves can be pulled forward as far as their built-in stops allow.
Storage Features DRAWERS Your refrigerator includes a variety of storage drawers. These drawers usually are located in fixed positions at the bottom of the fresh food compartment. Crisper NOTE Leafy vegetables keep best when stored with the Humidity Control set on Higher Humidity, or in a drawer without a Humidity Control.
DOORS Storage Bins The doors to your freezer and fresh food compartments use a system of modular storage bins. All of these bins are removable for easy cleaning. Some of them have fixed positions, while others can be adjusted to your needs. Door bins are ideal for storing jars, bottles, cans, and large drink containers.
The tall bottle retainer keeps tall containers in the bin from falling forward when opening or closing the refrigerator door. To install, snap the ends of the retainer over the edge of the retainer wall as shown in the illustration.
Automatic Ice & Water Dispenser USING THE DISPENSER Your automatic ice & water dispenser includes a control panel, a drinking glass bay, and two push-paddles for turning on the ice and water supplies. Using the dispenser control panel is necessary for the ice dispenser but not the water dispenser.
Automatic Ice & Water Dispenser PRIMING THE WATER SUPPLY SYSTEM Your refrigerator’s water supply system includes several tubing lines, an advanced water filter, a distribution valve bank, and a reserve tank to ensure ample supply to the ice and water dispenser at all times. This system needs to be completely filled with water when first connected to an external supply line.
The ice maker is turned on at the factory so it can work as soon as you install your refrigerator. If you cannot connect a water supply, turn the ice maker’s On/Off switch to Off. Otherwise, the ice maker’s fill valve may be noisy when it attempts to operate without water.
• Occasionally shake the ice container to keep ice separated. • If your refrigerator is not connected to a water supply or the water supply is turned off, turn off the ice maker by pressing the On/Off switch.
Automatic Ice & Water Dispenser To clean the ice dispenser: 1 Turn off ice production by pressing the ice maker’s Off/On switch. 2 Remove the ice bin by lifting up and out. 3 Empty and carefully clean the ice bin with mild detergent. Rinse with clear water.
Press and hold the Filter Reset button for 3 seconds again to turn off the filter status system. NOTE The electronic control panel, located at the top of the refrigerator compartment, includes controls to monitor the status of your air filter. See the previous section for more information about these controls.
ORDERING REPLACEMENT FILTERS Order new filters through the dealer where you bought your refrigerator, or contact the Electrolux Customer Care Center at 1-877-435-3287, or go to our web site at www.electroluxusa.com. You may want to consider ordering extra filters when you first install your refrigerator.
Please contact the Electrolux Customer Care Center at 1-877-435-3287 or visit our web site at www.electroluxusa.com to order the bypass (Part No.
Changing The Filter To replace your pure advantage It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. The bottom of the filter housing includes two small water drainage holes, so be sure to remove any stored food from the top shelf.
• Keep the fresh food compartment between 34° F and 40° F with an optimum temperature of 37° F (see page 13 for more about temperature settings). • Avoid overcrowding the refrigerator shelves, which reduces air circulation and causes uneven cooling.
IDEAS FOR SAVING ENERGY Installation • Locate the refrigerator in the coolest part of the room, out of direct sunlight, and away from heating ducts or registers. Do not place the refrigerator next to heat-producing appliances such as a range, oven, or dishwasher. If this is not possible, a section of cabinetry or an added layer of insulation between the two appliances will help the refrigerator operate more efficiently.
Normal Operating Sounds & Sights UNDERSTANDING THE SOUNDS YOU MAY HEAR Your new high-efficiency refrigerator may introduce unfamiliar sounds. These sounds normally indicate your refrigerator is operating correctly. Some surfaces on floors, walls, and kitchen cabinets may make these sounds more noticeable. NOTE Energy efficient foam in your refrigerator is not a sound insulator.
UTION UTION • Pull the refrigerator straight out to move it. Shifting it from side to side may damage flooring. Be careful not to move the refrigerator beyond the plumbing connections. • Damp objects stick to cold metal surfaces. Do not touch refrigerated surfaces with wet or damp hands.
Tips Short Vacations • Leave refrigerator operating during vacations of 3 weeks or less. • Use all perishable items from refrigerator compartment. • Turn automatic ice maker off and empty ice bucket, even if you will only be gone for a few days.
Care & Cleaning REPLACING LIGHT BULBS Both the freezer and fresh food compartments of your refrigerator include light bulbs that will need replacing from time to time. Some lights have covers that you will need to remove before replacing the bulbs. Always use bulbs that are designed for appliance lighting.
State of Alaska) In the U.S.A., your appliance is warranted by Electrolux Home Products, Inc. We authorize no person to change or add to any of our obligations under this warranty. Our obligations for service and parts under this warranty must be performed by us or an authorized Electrolux Home Products, Inc.
Solutions To Common Problems BEFORE YOU CALL... If you experience a problem with your refrigerator or notice a product behavior or condition you do not understand, you can usually avoid a call to your service representative by referring to this section for an answer. Beginning with the following table, this information includes common problems, causes, and suggested solutions.
Correction • Set freezer control to a warmer setting. Allow 24 hours for temperature to stabilize. • Set refrigerator control to a warmer setting. Allow 24 hours for temperature to stabilize. • See solution above. • Adjust Meat Keeper temperature control to a lower setting.
• This is normal in humid weather. When humidity is lower, the moisture should disappear. • Door is slightly open, causing cold air • See Problem section Opening/Closing Of from inside refrigerator to meet warm Doors/Drawers. air from outside. Cause Correction •...
Solutions To Common Problems Ice Dispenser Problem Cause Dispenser will not • Water supply is not connected. dispense ice. • Ice storage container is empty. • Freezer temperature is set too warm. • Household water line valve is not open. •...
• Door was closed too hard, causing other Door(s) will not close. door to open slightly. • Refrigerator is not level. It rocks on the floor when moved slightly. • Refrigerator is touching a wall or cabinet. • Food is touching shelf on top of drawer.