Saving Data To A Usb Storage Device - Toshiba E-STUDIO2000AC Scanning Manual

Saving Data to a USB Storage Device

0.
You can store scans to a USB storage device.
 To store data in a USB storage device, the Save to USB Media setting must be enabled by the administrator. For
details, refer to the TopAccess Guide.
 USB storage devices must meet requirements below. However, some USB storage devices may not be used with
this equipment even though the requirements below are met.
- FAT16 or FAT32 format
- Single-partition (USB storage devices with multiple partitions are not supported.)
Connect a USB storage device to the USB port of the equipment and wait a few seconds.
1
For the USB port position, refer to the Quick Start Guide.
2 When "Found USB Device." message appears on the touch panel, place the original(s) and press
[USB] on the Scan menu.
 To learn how to place originals, refer to the Paper Preparation Guide.
 For details on the Scan menu screen, see the following section:
 P.14 "Viewing the Scan Menu on the Touch Panel"
When you store scans in a USB storage device, never attempt to remove the device from the equipment until data
transmission is completed. Removing the USB storage device during data transmission may corrupt the device.
 Storing scans to a USB storage device may take a long time depending on the volume of the scans.
 To scan 2-sided documents or set Color Mode or Resolution, etc., press [Scan Setting].
 P.38 "Changing Scan Settings"
 To preview your scans, press [Preview] and then scan.
 P.47 "Previewing Scans"
 You can select and set [e-Filing], [E-mail] or [USB] as another scan function. (Dual Agents)
 P.54 "Scanning With Dual Functions (Dual Agents)"

Saving Data to a USB Storage Device 29