Filling the water container
Switch the appliance on.
Pull the water container forwards to
remove it.
Clean it thoroughly with water to
remove any dust etc.
Fill the container up to the marker
with fresh, cold drinking water.
Insert the filled water container into
the holder and push it all the way to
the back.
Make sure that the water container
clicks into position and that it is
sitting correctly in its holder.
Make sure that the ice cube drawer is
empty.
Making ice cubes
Switching the ice cube maker
on and off
Touch the settings sensor.
All symbols available for selection will
appear in the display and the symbol
flashes.
Touch the sensors for setting the
temperature (or ) repeatedly until
the the ice cube maker symbol
flashes in the display.
Touch the OK sensor to confirm your
selection.
Use the and sensors to set the
ice cube maker:
0: Ice cube maker is switched off
1: Ice cube maker is switched on
Touch the OK sensor to confirm your
selection.
The selected setting is applied.
Touch the settings sensor to leave
settings mode or
Close the appliance door.
Otherwise the appliance will switch to
normal operation after approximately
one minute.
49