Table of Contents
Advertisement
Software installation
Your multifunctional copier has been shipped with the installation and application software
needed to perform printing, scanning and PC fax functions. Windows Operating Systems
3.1x, 95, 98, and NT 4.0 are supported.
As well as a printer driver and a scanner driver, the Installation CD also contains on-line
documentation files, a printer monitor for easy access to printing status and printer care,
and a printer set-up utility program (CONFIG.EXE), for personalised printer settings under
DOS (see DOS environment ).
To install the machine software, follow the instructions in "Software installation procedure
(Windows® ® ® ® environment)" . To install an application, read the instructions supplied with
the individual programs.
System requirements
•
For Windows® 3.1x: PC 486 or better; at least 16 Mbytes RAM.
•
For Windows® 95/98: PC 486 or better; at least 32 Mbytes RAM.
•
For Windows® NT: Pentium; at least 32 Mbytes RAM.
All configurations require at least a VGA monitor and a parallel IEEE 1284 interface
connection.
The drivers and documentation files copied to your hard disk during software
installation will occupy approximately 20 Mbytes of disk space.
If your PC does not have a CD-ROM drive, you can create 3.5 inch diskettes from the "create
disk" utility on this installation CD. You will need to locate a computer that has both a CD-
ROM drive and a 3.5-inch diskette drive. To create the diskettes follow the procedure given
on the Installer introductory screens.
Software installation
13
Advertisement
Table of Contents
