Table of Contents
Advertisement
G-SERIES ONLY: Secure the oil cooler support to the
left and right lower frame legs using existing hardware
from the bumper removal. It may be necessary to loosen
all hardware on the oil cooler support in order to align
the mounting hole on the frame leg. Once the support is
secured to the leg, tighten all hardware. Refer to Figure
2-2b and 2-2c.
Oil Cooler
Support
Existing
Hardware
Figure 2-2c
Existing
Hardware
2-3 Lower Mount Assembly
Installation
G-Series: Secure the lower mount assembly P#(A0672)
to the rear frame of the mower using (2) 3/8"-16 x 1"
HHCS P#(K1191) and (2) 3/8"-16 nylon flange locknuts
P#(K2038). Refer to Figure 2-3a.
Lower Mount
Assembly
Figure 2-2b
Left Lower
Frame Leg
Oil Cooler
Support
Right Lower
Frame Leg
(2) 3/8"-16 x 1" HHCS
(2) 3/8"-16 Nylon
Flange Locknut
Figure 2-3a
F-Series: To mount the lower mount assembly
P#(A0672) to the rear of the mower, first remove the
mower's (4) existing nuts and bolts. Once the nuts and
bolts are removed place the lower mount assembly onto
the rear of the mower, and secure using the (4) existing
nuts and bolts that were removed from the mower
(Figure 2-3b).
Figure 2-3b
Bolts and Nuts
2-4 Rear Brace Installation
G-SERIES ONLY: Secure (1) rear brace P#(B0668) to
the lower mount assembly and the left lower frame leg.
Use (2) 3/8"-16 x 1" HHCS P#(K1191) and (2) 3/8"-16
nylon flange locknuts P#(K2038). Secure (1) rear brace
P#(B0668) to the lower mount assembly and the right
lower frame leg. Use (2) 3/8"-16 x 1" HHCS P#(K1191)
and (2) 3/8"-16 nylon flange locknuts P#(K2038). Refer
to Figure 2-4.
Lower Mount
Figure 2-4
Rear
Brace
(2) 3/8"-16 x 1 " HHCS
Left Lower
(2) 3/8"-16 Nylon Flange
Frame Leg
6
Lower Mount Assembly
(4) Existing
Rear
Assembly
Brace
Right Lower
Frame Leg
Locknut
Advertisement
Table of Contents
