Table of Contents
Advertisement
2-10 Hinge Kit Assembly Installation
Assemble the hinge kit as shown in Figure 2-10, using
(2) 5/16"-18 x 1" HHCS P#(K1154), (3) 5/16"-18 nylon
flange locknuts P#(K2516), (5) 1/4" flat washers
P#(K0037) and (2) swing arm brackets P#(ZT-0004).
Place (1) vinyl cap P#(J0289) on the end of the hex bolts
as shown in Figure 2-10. Leave the nuts loose enough to
allow fluid movement of the top when opening and
closing. When opened, the top should rest on the middle
joint of the hinge allowing it to remain up.
Figure 2-10
K1154
K2516
J0289
ZT-0004
2-11 Boot to Mower Deck Installation
Secure the boot plate P#(B0673) to the mower deck
using (1) boot rod P#(B0288) and (1) hair pin clip
P#(K0099). Secure the boot P#(E1030) to the boot plate
using (2) 3/8"-16 x 1" carriage bolt P#(K1182), (2) 3/8"
flat washer P#(K0047), and (2) 3/8"-16 nyloc nut
P#(K1216). Insert the carriage bolt from the inside of the
boot so that the threads are on the outside. This will
prevent grass clippings from collecting on the threads.
Refer to Figure 2-11.
Figure 2-11
Hair Pin Clip
Boot
K0037
Boot Rod
Boot Plate
(2) 3/8"-16 x 1" Carriage Bolt
(2) 3/8" Flat Washer
(2) 3/8-16 Nyloc Nut
2-12 Blower Cone Installation
Thread (1) 5/16"-18 jam nut P#(K0120) onto each end of
(2) 5/16"-18 x 2-1/2" HHCS P#(K0125) as shown in
Figure 2-12a.
Now partially thread (1) bolt into each of the two
threaded bosses located on the blower housing. Place
blower cone so the two tabs line up with the bolts and
tighten completely as shown in Figure 2-12b.
Figure 2-12b
Threaded
Boss
Once the (2) bolts are tight, tighten the jam nuts against
the threaded boss as shown in Figure 2-12c.
Figure 2-12c
(2nd) Tighten
Jam Nut
Refer to Figure 2-12d for proper blower cone installation
reference.
Figure 2-12d
Blower
Cone
9
Figure 2-12a
Thread (1) Jam Nut
Onto Each 5/16"-18 Bolt
Blower
Cone Tab
(1st) Tighten
Bolt
Advertisement
Table of Contents
