Top Link; Telescopic Stabilizers - Kubota M8540 NARROW Operator's Manual

BTop Link
1. Adjust the angle of the implement to the desired
position by shortening or lengthening the top link.
2. The proper length of the top link varies according to
the type of implement being used.

(1) Top link

A The length of the screw at both ends of the top link
must be the same always.
BTelescopic Stabilizers
Adjust the telescopic stabilizers to control horizontal sway
of the implement. Select the proper set of holes by
referring to the "Hydraulic Control Unit Use Reference
Chart" in "REMOTE HYDRAULIC CONTROL SYSTEM"
in "HYDRAULIC UNIT" section.
After aligning satisfactorily, insert the set-pin through one
of the two holes on the outer tube that align with one of the
holes on the inner bar, both stabilizers will be locked.
If the set-pin is inserted through the slot to engage one of
the holes on the inner bar, a limited degree of sway will be
permitted.
(A) "Length of the screw"
THREE-POINT HITCH & DRAWBAR
(1) Outer tube
(2) Inner bar
(3) Set-pin
(1) Set-pin
(2) Hairpin cotter
39
(4) Hole
(5) Slot