Adjusting Front Axle Pivot; Every 800 Hours; Adjusting Engine Valve Clearance; Every 1500 Hours - Kubota M8540 NARROW Operator's Manual

80 PERIODIC SERVICE
Front Axle Gear Case
Front Differential Case
(1) Drain plug
(2) Filling plug
(3) Check plug
A Do not remove the bolt(A).
(1) Bolt(A)
Oil capacity
3.0 L for each side
5.0 L
BAdjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, screw-in the adjusting screw until
seated, then tighten the screw with an additional 1/6 turn.
Re-tighten the lock nut.
(1) Adjusting screw
(2) Lock nut

EVERY 800 HOURS

BAdjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.

EVERY 1500 HOURS

BChecking Fuel Injection Nozzle (Injection
Pressure)
Consult your local KUBOTA Dealer for this service.

EVERY 3000 HOURS

BChecking Turbocharger
Consult your local KUBOTA Dealer for this service.
BChecking Injection Pump
Consult your local KUBOTA Dealer for this service.
BChecking Intake Air Heater
Consult your local KUBOTA Dealer for this service.