Indoor Unit Installaion - Haier AF09AS1ERA Operation Manual

Indoor Unit Installaion

Necessary Tools for Installation
Driver
Nipper
Hacksaw
Hole core drill
Spanner(17,19 and 26mm)
Gas leakage detector or
soap-and-water solution
Selection of Installation Place
Place, robust not causing vibration, where the body can
be supported suf ciently.
Place, not affected by heat or steam generated in the
vicinity, where inlet and outlet of the unit are not disturbed.
Place, possible to drain easily, where piping can be
connected with the outdoor unit.
Place, where cold air can be spread in a room entirely.
Place, nearby a power receptacle, with enough space
around.
Place where the distance of more than lm from
televisions, radios, wireless apparatuses and
uorescent lamps can be left.
In the case of xing the remote controller on a wall,
place where the indoor unit can receive signals when the
uorescent lamps in the room are lightened.
The models adopt HFC free refrigerant R410A
more than 10cm
more than 60 cm
Torque wrench
(17mm,22mm,26mm)
Pipe cutter
Flaring tool
Knife
Measuring tape
Reamer
Drawing for the installation of indoor units
more than cm
20
more than 10cm
Before inserting power into receptacle, check the voltage
without fail.
The power supply is the same as the corresponding
nameplate.
Install an exclusive branch circuit of the power.
A receptacle shall be set up in a distance where the power
cable can be reached.Do not extend the cable by cutting it.
Accessory Parts
Remote controller (1)
R-03 dry battery (2)
Mounting plate (1)
Selection of Pipe
FOR 09K 12K
FOR 18K
Attention must be paid to
the rising up of drain hose
Power Source
Drain hose (1)
Plastic cap (4)
Ø4X25 Screw (4)
Air purifying filter(Optional) (1)
Arrangement of piping
directions
Rear left
Rear
Left
right
Right
Below
5