Table of Contents
Advertisement
Remote control (RUE-4119)
a Avoid dropping this remote control or placing it in pants pockets. Doing so may cause
damage to the case or buttons, shorten battery life or cause the system to malfunction.
a To clean this device, wipe it with a dry cloth. (If it is extremely dirty, wipe it with a wrung
damp cloth.) Never use benzene, paint thinner or harsh chemicals which can cause
Tips
deterioration of the case or paint.
a Do not expose this remote control to direct sunlight (i.e. on the dashboard) for extended
periods of time.
Replacing the batteries
Use two AA-type batteries.
1
Open the cover
Opening the battery cover.
Push on the cover and slide it as
indicated by the arrows then the
cover will be removed.
Remote Control Holder Installation
• If direct sunlight reaches the remote control
mounted on the holder, remove the remote
control from the holder and put it in the
glove compartment.
• If double-sided adhesive tape cannot install
the holder securely, use screws.
Note: Attach the blue protective paper side
of double-sided tape onto the console
box, etc.
Replace the
2
batteries
Replacing the battery.
Remove the old batteries. Insert
new ones matching the (+) and (–)
polarities as shown in the diagram
inside the remote control.
−
+
Blue Protective
Paper
3
Close the cover
Closing the cover.
Push the cover in the arrow
direction until a click is heard.
+
−
Reinforcing Screws
Console Box etc.
Remote
Control
Remote Control
Holder
Double-Sided
Adhesive Tape
(Before attaching
the tape, remove
dust from the
surface of
attaching place.)
11
Advertisement
Table of Contents
