Key Repeat Initial Delay; Key Repeat Rate; Wiper Message; Clear Custom Status - Oki MB 780 Service Manual

Key Repeat Initial Delay

When a key is touched repeatedly, this is the delay before the key begins repeating. The
delay ranges from 0.25 seconds to 5 seconds. The default is 1 second. Values are given in
increments of 0.25 seconds.
To change this setting:
• Select Key Repeat Initial Delay from the Configuration Menu.
• Select ► to increase value or ◄ to decrease value.
•
Select "Submit" to save your change. Select "Back" to exit without changing.

Key Repeat Rate

This is the number of times per second that a repeating key will repeat. The range is 1–
100, with a default of 15 times per second.
To change this setting:
• Select Key Repeat Rate from the Configuration Menu.
• Select ► to increase value or ◄ to decrease value.
•
Select "Submit" to save your change. Select "Back" to exit without changing.

Wiper Message

To change this setting:
• Select Wiper Message from the Configuration Menu.
• Select ◄ or ► to change the setting. . The values are On (default) and Off.
•
Select "Submit" to save your change. Select "Back" to exit without changing.

Clear Custom Status

No values exist for this operation. Pressing √ initiates this operation.
• Select Clear Custom Status from the Configuration Menu.
Note: Executing this operation erases any strings that have been defined by
the user for the default or alternate custom messages.
•
Select "Submit" to save your change. Select "Back" to exit without changing.
41