Table of Contents
Advertisement
Connecting up
6.6 Connecting to Industrial Ethernet
6.6
Connecting to Industrial Ethernet
With the W786, the Ethernet cable is connected via an RJ-45 jack (copper cable). The
following figure shows the position of the Ethernet interface with the housing cover open:
Figure 6-6
Device variant W786-x RJ-45
Follow the steps below to connect an Ethernet cable to a SCALANCE W786 with an RJ-45
jack:
1. Insert the RJ-45 plug of the Ethernet cable in the jack of the SCALANCE W786-x RJ-45.
2. Secure the Ethernet cable with a strain relief clamp.
Note
Keep the dummy plugs
Keep any dummy plugs taken out of the slots for later use.
See also
Suitable cables for power supply and Ethernet (Page 37)
48
Position of the Ethernet interface
Operating Instructions, 11/2014, A5E03678337-07
SCALANCE W786-x
Advertisement
Table of Contents
